Showing Spotlights 2649 - 2656 of 2851 in category All (newest first):
Artificial opals are gemstones that are of considerable scientific and technological interest as photonic crystals, as components of light sources, solar cells, and chemical sensors. They are conveniently made from periodic stackings of nanospheres. It would be exciting if one could fabricate optical cavities in these photonic crystals by removing, or adding high dielectric material to a single unit cell in the structure. These optical cavities would localize light that potentially enables the fabrication of high-resolution miniature on-chip sensors, or even qubits for quantum computers. Previously, such controlled modification of the nanostructure of a single colloid in an opal has not been achieved. Now, researchers in The Netherlands developed a method for realizing both single and arrays of material cavities, or defects, in individual colloids on the surface of silicon dioxide artificial opals by a focused ion beam milling technique. This research could ultimately lead to the fabrication of a photon-on-demand light source.
Nov 30th, 2006
While the first reported fullerenes and nanotube structures were composed of carbon, it was soon recognized that a plethora of comparable inorganic candidates should also exist. A rich assortment of IF (inorganic fullerene-like structures, or IF for short) nanostructures have been synthesized, and are finding practical uses in tribology, photonics, batteries, and catalysis. On such inorganic molecule that can achieve fullerene-like nanostructures, cesium oxide, is particularly useful for a multitude of applications in photoemissive systems. Unfortunately, it is extremely reactive in the ambient atmosphere, so its production and handling require high vacuum and very pure inert conditions; which translates into problematic and expensive manufacturing and handling, which in turn limits its technological scope and device lifetime. In their quest for a relatively uncomplicated high-yield synthesis method for chemically stable cesium oxide IFs, scientists succeeded in exploiting highly concentrated solar radiation (ultrabright incoherent light) toward that end. This resulted in a simple, inexpensive, and reproducible photothermal procedure for synthesizing IF nanoparticles.
Nov 29th, 2006
Wound healing is a complex process and has been the subject of intense research for a long time. Wound healing proceeds through an overlapping pattern of events including coagulation, inflammation, proliferation, and matrix and tissue remodeling. The holy grail for wound healing is accelerated healing without scars. Silver has been used for centuries to prevent and treat a variety of diseases. Its antibacterial effect may be due to blockage of the respiratory enzyme pathways and alteration of microbial DNA and the cell wall. In addition to its recognized antibacterial properties, some authors have reported on the possible pro-healing properties of silver. The use of silver in the past has been restrained by the need to produce silver as a compound, thereby increasing the potential side effects. Nanotechnology has provided a way of producing pure silver nanoparticles and this has provided a new therapeutic modality for use in burn wounds. Nonetheless, the beneficial effects of silver nanoparticles on wound healing remain unknown. A new study reports that silver nanoparticles can promote wound healing and reduce scar appearance.
Nov 28th, 2006
Nano-this and nano-that. Nanotechnology moves into the public consciousness. This 'nanotrend' has assumed 'mega' proportions: Patent offices around the world are swamped with nanotechnology-related applications; investment advisors compile nanotechnology stock indices and predict a coming boom in nanotechnology stocks with estimates floating around of a trillion-dollar industry within 10 years; pundits promise a new world with radically different medical procedures, manufacturing technologies and solutions to environmental problems; nano conferences and trade shows are thriving all over the world; scientific journals are awash in articles dealing with nanoscience discoveries and nanotechnology breakthroughs. Nanotechnology has been plagued by a lot of hype, but cynicism and criticism have not been far behind. The media can run amok when news about potential health problems with nanoproducts surface (as recently happened with a product recall for a bathroom cleaner in Germany). These discussions around nanotechnology epitomize the contemporary processes of making the future present. An interesting approach to dealing with the lack of consensus in the views on nanotechnology identifies eight main nodes of nanotechnology discourse and describes these "islands" of discussion, examines their interactions and degrees of isolation from each other.
Nov 27th, 2006
Carbon nanotubes (CNTs) have great potential applications in making ballistic-resistance materials. The remarkable properties of CNTs makes them an ideal candidate for reinforcing polymers and other materials, and could lead to applications such as bullet-proof vests as light as a T-shirt, shields, and explosion-proof blankets. For these applications, thinner, lighter, and flexible materials with superior dynamic mechanical properties are required. A new study by researchers in Australia explores the energy absorption capacity of a single-walled carbon nanotube under a ballistic impact. The result offers a useful guideline for using CNTs as a reinforcing phase of materials to make devices to prevent from ballistic penetration or high speed impact.
Nov 22nd, 2006
If current research is an indicator, wearable electronics will go far beyond just very small electronic devices. Not only will such devices be embedded on textile substrates, but an electronics device or system could become the fabric itself. Electronics textiles will allow the design and production of a new generation of garments with distributed sensors and electronic functions. Such e-textiles will have the revolutionary ability to sense, act, store, emit, and move (think biomedical monitoring functions or new man-machine interfaces) while leveraging an existing low-cost textile manufacturing infrastructure. Today, only a few steps towards new architectural possibilities of realizing circuit topologies that can be implemented with textile technique have been made: one an example of nonplanar devices and one of textile based devices. Researchers in Italy have now developed an organic field effect transistor (OFET) fully compatible with textile processing techniques.
Nov 21st, 2006
You might have seen our recent Nanowerk Spotlight on modern military nanotechnology (Military nanotechnology - how worried should we be?) and read about the hundreds of millions of dollars that the U.S. military pours into nanotech research every year. Well, it turns out that metalsmiths in India perhaps as early as 300 AD, and presumably with a much lower budget, developed a new technique known as wootz steel that produced a high-carbon steel of unusually high purity. Wootz, which are small steel ingots, was widely exported and became particularly famous in the Middle East, where it became known as Damascus steel. This steel had extraordinary mechanical properties and an exceptionally sharp cutting edge. The original Damascus steel swords were made possibly as early as 500 AD to as late as 1750 AD. What's so interesting about this? It turns out that the secret of Damascus steel is carbon nanotubes. Recently discovered in the nanostructure of a 17th century Damascus saber, the nanotubes could have encapsulated iron-carbide (cementite) nanowires that might give clues to the mechanical strength and sharpness of these swords.
Nov 20th, 2006
The electrical properties of CNTs are extremely sensitive to defects which can be introduced during the growth, by mechanical strain, or by irradiation with energetic particles such as electrons, heavy ions, alpha-particles, and protons. When highly energetic particles collide, a latchup, electrical interference, charging, sputtering, erosion, and puncture of the target device can occur. Therefore the information on the effects of various types of high energetic irradiation on CNTs and other nanomaterials will be important in developing radiation-robust devices and circuits of nanomaterials under aerospace environment. As a result, degradation of the device performance and lifetime or even a system failure of the underlying electronics may happen. Researchers in South Korea conducted a systematic study of the effects of proton irradiation on the electrical properties of CNT network field effect transistor (FET) devices showing metallic or semiconducting behaviors. The most important outcome of this work is that no significant change in the electrical properties of CNT-based FET was observed, even after high-energy proton beam irradiated directly on the device. This result show that CNT-based devices can be a promising substitute for classical silicon-based devices, which are known to be very fragile against proton radiations
Nov 17th, 2006
Subscribe to our Nanotechnology Spotlight feed